Hot-applied bituminous mastic: uses and selection criteria

What is bituminous mastic?

Bituminous mastic is a material used to seal cracks and joints. Hot-applied single-component versions require special equipment and must not be confused with sealants ready for use at room temperature.

The choice depends on the substrate, the type of work, and the documented characteristics of the product. A generic description is not sufficient to determine suitability for a specific pavement or roofing application.

What is hot bituminous mastic used for?

Products in this family are intended for sealing cracks in asphalt and concrete, as well as for work on roads, joints, and roofs. However, each application must be checked against the intended use of the selected grade.

Work Checks before selection
Cracks in asphalt Pavement condition, crack geometry, and required preparation.
Cracks in concrete Substrate condition and stated sealant compatibility.
Expansion joints Dimensions, expected movements, and documented material performance.
Roofing work Compatibility with existing layers and the system's specified procedure.

How is the application temperature determined?

The temperature must be the one specified in the technical data sheet of the product actually used. There is no value that can be automatically applied to any bituminous mastic.

Before starting the work, check the heating instructions, the required equipment, the substrate conditions, and the precautions listed in the safety data sheet. This guide does not replace an on-site operating procedure.

What information is needed to request the product?

  • Surface type and substrate condition.
  • Type and dimensions of the cracks or joints.
  • Expected operating and exposure conditions.
  • Equipment available for application.
  • Approximate quantity and purpose of the supply.

Consumption rates, traffic reopening times, and deformability performance must be obtained from the documentation for the selected grade. It is incorrect to assume standard values without knowing the material and the work.

Frequently asked questions

Can hot bituminous mastic be applied cold?

No: a formulation intended for hot application requires the preparation and equipment specified by the manufacturer. For cold application, a product specifically designed for that purpose must be selected.

Is it suitable for both asphalt and concrete?

Products are available for these applications, but compatibility must be checked in the technical data sheet of the proposed material.

Is there a universal consumption rate?

No. The required quantity depends on the size of the work and the product data. To obtain an estimate, the geometry of the cracks or joints must be provided.

Technical information

Contact Pigment Al and provide the substrate, application, and approximate quantity to request information about the material to be considered.