AR Glass Microfiber for Mortars and Coatings
AR glass microfiber is an alkali-resistant reinforcement used in cement mortars, plasters, microcement, and thin coatings. Distributed throughout the mix, it helps limit shrinkage microcracking. Fibratec V13-MO is a high-zirconia microfibre with 13.5 µm filaments; dosage and mixing methods should be verified according to the formulation and required performance.
In brief
- Type: high-zirconia AR glass microfibre
- Filament diameter: 13.5 µm
- Specific gravity: 2.68 g/cm³
- Melting temperature: over 1,500 °C, not to be confused with the operating temperature
- Applications: mortars, plasters, microcement, and cementitious coatings
Technical characteristics of Fibratec V13-MO
| Parameter | Value |
|---|---|
| Material | AR alkali-resistant glass |
| Filament diameter | 13.5 µm |
| Specific gravity | 2.68 g/cm³ |
| Melting temperature | > 1,500 °C |
| Form | Loose filaments |
| Uses | Mortars, plasters, microcement, and cementitious coatings |
Applications of glass microfibre
Fibre-reinforced mortars and plasters
The microfibre is distributed throughout the mortar mix to create three-dimensional reinforcement and help limit microcracking caused by shrinkage and stress.
Microcement and thin coatings
The small filament diameter promotes uniform reinforcement of mixes and thin coatings. Surface uniformity and any visibility of the fibres depend on the dosage, proper dispersion in the mix, the applied thickness, and the finishing methods.
Melting temperature and usage limits
The melting temperature reported for Fibratec V13-MO is over 1,500 °C. This figure does not correspond to the operating temperature and does not, on its own, demonstrate the product's suitability for high-temperature applications. For such uses, the manufacturer's instructions and the performance of the entire cementitious system must be verified.
Glass microfibre and polypropylene fibre
| Characteristic | AR glass microfibre | Polypropylene fibre |
|---|---|---|
| Specific gravity | 2.68 g/cm³ | 0.9 g/cm³ |
| Melting temperature | > 1,500 °C | Approximately 173 °C |
| Behaviour in the mix | Distribution depends on the fibre's characteristics, the dosage, and the mixing. | Distribution depends on the fibre's characteristics, the dosage, and the mixing; density alone does not determine behaviour. |
Dosage and incorporation
The dosage must be determined based on the formulation, the applied thickness, and the required performance. If no value is documented in the available data sheet, it is advisable to conduct preliminary tests and follow the product's specific technical instructions.
FAQ on Glass Microfibre
Does Fibratec V13-MO leave marks on the surface?
The filament diameter of 13.5 µm promotes uniform finishes. However, any visibility of the fibres depends on the dosage, dispersion, thickness, and surface treatment. It is advisable to verify the result with preliminary tests using the intended formulation.
Can it replace plaster mesh?
Microfibre creates three-dimensional reinforcement throughout the mix. However, any replacement of mesh must be assessed based on the application system, thickness, and design requirements.
Is it suitable for high-temperature applications?
The reported melting temperature is over 1,500 °C, but this should not be interpreted as the maximum operating temperature. Suitability for high-temperature applications must be verified with the manufacturer and through tests on the complete system.
How does it differ from polypropylene fibres?
AR glass microfibre has a specific gravity of 2.68 g/cm³ and a melting temperature over 1,500 °C; polypropylene has lower density and melting temperature. These figures alone are not enough to determine which fibre is more suitable: the choice requires an assessment of the formulation and the required performance.