Biocides in jars

In-Can Biocides for Water-Based Paints: MIT, BIT and CMIT

In-can biocides (in-can preservatives) are preservatives that protect water-based paints from microbial degradation during storage. Bacteria and fungi present in the process water or introduced during production can degrade the organic components of the paint, causing loss of viscosity, unpleasant odors, pH variations, and phase separation.

This guide concerns the preservation of liquid paint. For a comparison of the two functions, see the general guide to biocides for water-based paints; for the protection of the dried coating, read the in-depth guide on wall biocides.

Active ingredients described

Among the preservatives mentioned for this use are MIT, BIT, and CMIT. The active ingredient abbreviation alone does not identify the commercial product nor automatically determine its suitability and dosage: check the concentration, compatibility with the formulation, and the supplier's updated documentation.

Signs to investigate during storage

  • Loss or abnormal variation of viscosity
  • Unpleasant odor
  • pH variation
  • Phase separation
  • Abnormal discoloration or presence of mold in the container

These signs require an assessment: they do not by themselves constitute a diagnosis of microbial contamination. Avoid correcting the batch by adding preservative without a technical verification of the cause and the conditions of the product.

Dosage and addition to the formulation

Define the dosage and addition point according to the technical data sheet of the specific preservative. Before comparing percentages, distinguish the quantity of commercial product from that of the active ingredient and check the reference mass.

The initial aqueous phase and the completion are stages to be evaluated with the supplier depending on the system. Check compatibility with thickeners and binders, production conditions, and stability during storage; do not automatically transfer the instructions from one preservative to another.

Documentation and checks before use

Consult the technical data sheet, safety data sheet, and updated documentation for the intended use. The selection of the preservative and the labeling obligations must be verified on the actual product and the formulation, without deducing them from the mere presence of MIT, BIT, or CMIT.

Consult our in-can biocides for water-based paints in 25 kg buckets to request information on the product and the available documentation.

Frequently asked questions about in-can preservation

Why can paint viscosity decrease during storage?

The microbial degradation of formulation components, including HEC, can contribute to the loss of viscosity. However, the cause must be verified: a variation in viscosity does not by itself prove contamination.

Is there a single dosage for MIT, BIT, and CMIT?

No: the active ingredient abbreviation is not enough to define the percentage to use. The concentration of the commercial product, the supplier's instructions, and verification on the actual formulation are required.

Does in-can protection also protect the wall from mold?

The two functions are distinct. For the protection of the dried film, consult the guide to wall biocides; for a summary of the differences, return to the comparison of biocides for water-based paints.

In-can biocides for water-based paints

For information on the preservative suitable for your formulation and the available documentation, contact our team.