Wall-mounted biocides

Dry Film Preservatives: Protection of the Dried Film

Dry film preservatives are used to protect the dried film of water-based paints from the growth of mold, algae, and fungi. This guide concerns the coating after application, not the stability of the liquid paint in the container.

To navigate between the two uses, consult the comparison of biocides for water-based paints. If the problem concerns odor, viscosity, or product preservation during storage, read the guide to container biocides instead.

Assess the Coating and Exposure

To choose the film protection, you need to consider whether it is for indoor or outdoor use, the exposure of the facade, humidity, and the characteristics of the paint. Coating protection does not replace the verification of the causes of leaks, condensation, or persistent moisture.

The presence of stains or films is not enough to identify the microorganism or choose an active ingredient. The substrate and painting system must be assessed, along with the product documentation.

Active Ingredients and Reported Dosages

Active Ingredient Abbreviation Dosage Reported in the Article
Iodopropynyl butylcarbamate IPBC 0.05–0.15%
Octylisothiazolinone OIT 0.05–0.2%
Diuron — 0.1–0.3%
Terbuthylazine — 0.1–0.2%
IPBC/OIT Combination IPBC+OIT 0.05–0.2%

The percentages above are those already reported in the article and do not constitute a recipe applicable to any product. Before use, check with the supplier the concentration of the commercial product, the calculation basis, compatibility, and intended use. Do not infer the suitability or admissibility of an active ingredient for your application solely from its presence in the table.

Incorporation into the Formulation

Completion after the binder is the phase described for the products treated in this guide. The addition point, agitation, and temperature limits must be confirmed in the technical data sheet of the actual product; do not automatically extend the same instructions to every film preservative.

Check compatibility with the binder and other additives and assess performance on the finished coating. Dosage and process conditions must be defined on the actual formulation.

Documentation for Use

Consult the technical data sheet, safety data sheet, and updated documentation for the intended use. Verify the obligations applicable to the formulation and labeling without deriving them solely from the abbreviation of the active ingredient.

Consult our dry film preservatives for water-based paints to request technical information on the available product.

FAQ — Frequently Asked Questions

What is the difference between a container biocide and a dry film preservative?

A container biocide protects the liquid paint during storage. A dry film preservative protects the dried film from microbial growth on the surface. The two functions are distinct: their joint use must be assessed on the system, not assumed mandatory in every formulation.

What is the correct dosage of IPBC in water-based paints?

The range reported in the table is 0.05–0.15%, but it does not identify a universal dosage. For the actual product, you need to check the concentration, calculation basis, and supplier instructions before defining the quantity to use.

Do dry film preservatives also protect against algae?

Performance depends on the product and the painting system. Protection described against mold does not automatically demonstrate efficacy against algae: check the spectrum of action and documented results for the intended use.

Are dry film preservatives mandatory on the label?

Labeling obligations must be verified on the product and the actual formulation with the supplier's updated documentation and applicable requirements. It is not sufficient to use a generic wording equal for all active ingredients.

Dry film preservatives

For information on the product and available documentation, contact our team. To compare film protection and liquid product preservation, return to the general guide to biocides for water-based paints.