Biocides for water-based paints: what protection do you need?
Biocides for water-based paints serve two distinct functions: in-can preservatives protect the liquid paint during storage, while dry film biocides protect the film after it has dried. This guide compares the two uses; the dedicated sections describe their respective characteristics.
Comparison between in-can protection and dry film protection
| Aspect | In-can | Dry film |
|---|---|---|
| Phase to be protected | Liquid paint during storage | Dried film on the surface |
| Problem to assess | Microbial degradation of the formulation, changes in viscosity and odor | Growth of mold and algae on the coating |
| Technical designation | In-can preservatives | Dry film preservatives |
| Further reading | In-can biocides for water-based paints | Dry film biocides for wall protection |
The two functions are not interchangeable: protecting the product in the container does not mean protecting the wall after application. If they are to be used together, this must be assessed based on the formulation and intended use.

When to learn more about in-can preservatives
If the problem concerns the stability of the liquid paint, the assessment should focus on in-can preservation. Loss of viscosity, unusual odors, and phase separation are signs that should be investigated, without automatically attributing them to microbial contamination.
The guide to in-can biocides explores this function and the preservatives described, including MIT, BIT, and CMIT. The choice must be based on the specific product and the actual production and storage conditions.
When to learn more about dry film protection
If the assessment concerns mold or algae on the dried coating, it is necessary to distinguish dry film protection from in-can preservation. The type of exposure, humidity, and characteristics of the painting system are important factors.
The guide to dry film biocides explores this use and the differences between the actions described for the various active ingredients. A preservative for liquid paint should not automatically be considered suitable for this function.
How to interpret dosages in technical data sheets
There is no single percentage that applies to all biocides for water-based paints. Before comparing two dosages, check whether they are expressed in terms of the commercial product or the active ingredient, the concentration of the product, and the reference mass of the formulation.
Percentages should not be transferred from one preservative to another: the actual dosage requires up-to-date supplier documentation and verification of the formulation. This comparative guide does not propose a general range to be applied indiscriminately to the two categories.
Documentation for product selection
Before use, consult the technical data sheet, safety data sheet, and any documentation applicable to the product and intended use. The information in this article does not replace the verification of permitted uses and labeling requirements.
FAQ — Frequently Asked Questions
What is the difference between an in-can biocide and a dry film biocide?
An in-can biocide, such as MIT, BIT, or CMIT, protects liquid paint from bacterial degradation during storage. A dry film biocide, such as IPBC or OIT, protects the dried film from the growth of mold and algae on the surface. They have different functions and can be used together.
Why does HEC require an in-can biocide?
HEC, or hydroxyethyl cellulose, is a biodegradable polysaccharide that is subject to bacterial degradation in aqueous formulations. Bacteria can damage the polymer chains and cause a loss of viscosity. A suitable in-can preservative helps prevent this degradation.
Are biocides for water-based paints subject to regulations?
Yes. Biocides for water-based paints fall under EU Regulation 528/2012, known as the BPR. The active ingredients must be approved for the intended use, and the formulations must comply with the applicable labeling requirements.